Access point Cisco C9105AXI-EWC-E
881 $
Cisco Catalyst 9100 – an innovative series of corporate Internet access points that are equipped with state-of-the-art hardware and support modern patented technologies and methods Cisco.
Units of this level are profiled for modern high-tech firms and enterprises that value a high level of performance and safety..
Line of new hotspots Cisco Catalyst 9100 represented by the following models: Catalyst 9115, Catalyst 9117 And Catalyst 9120.
access point Catalyst 9115 – is a unique device based on 6-1st generation WI-FI or 802.11Oh, which provides a triple increase in the speed of receiving and transmitting an Internet signal.
Peculiarities
- Simultaneous operation on all frequencies
- Multi-gigabit network interface
- New power-saving mode extends battery life
- Technology support Trust Anchor, guaranteeing the authenticity of software and hardware
- Certification WIFI 6
- Three radio modules: 2,4 GHz, 5 GHz And Bluetooth Low Energy (BLE) 5.0
- Support OFDMA And MU-MIMO 4x4
Catalyst 9117 – enterprise-class wireless access point, it has a multi-gigabyte interface and supports frequency division technology OFDMA And MU-MIMO 8x8. In addition, the access point is equipped with three radio modules and supports up to five thousand connected clients..
Peculiarities
- Simultaneous operation on all frequencies
- Multi-gigabit network interface
- New power-saving mode extends battery life
- Technology support Trust Anchor, guaranteeing the authenticity of software and hardware
- Certification WIFI 6
- Three radio modules: 2,4 GHz, 5 GHz And Bluetooth Low Energy (BLE) 5.0
- Support OFDMA And MU-MIMO 8x8
Catalyst 9120 – the most progressive model among all access points based on a new data transfer protocol WI-FI 6. The model is equipped with 4 radio modules and is produced with both internal and external antennas..
Peculiarities
- Certification WIFI 6
- Four radio modules: 2,4 GHz, 5 GHz, 5 GHz (dedicated radio module) And Bluetooth Low Energy (BLE) 5.0
- Support OFDMA And MU-MIMO 8x8
- Simultaneous operation on all frequencies
- Multi-gigabit network interface
- New power-saving mode extends battery life
- Technology support Trust Anchor, guaranteeing the authenticity of software and hardware
|
Software |
- Cisco Unified Wireless Network Software Release 8.10.MR3 or later - Cisco IOS XE Software Release 17.3.1, or later |
|
Supported wireless LAN controllers |
- Cisco Catalyst 9800 Series Wireless Controllers - Cisco 3504, 5520, and 8540 Wireless Controllers and Cisco Virtual Wireless Controller |
|
802.11n version 2.0 (and related) capabilities |
- 2x2 MIMO with two spatial streams - Maximal Ratio Combining (MRC) - 802.11n and 802.11a/g - 20- and 40-MHz channels - PHY data rates up to 444.4 Mbps (40 MHz with 5 GHz and 20 MHz with 2.4 GHz) - Packet aggregation: Aggregate MAC Protocol Data Unit (A-MPDU) (transmit and receive), Aggregate MAC Service Data Unit (A-MSDU) (transmit and receive) - 802.11 Dynamic Frequency Selection (DFS) - Cyclic Shift Diversity (CSD) support |
|
802.11ac |
- 2x2 downlink MU-MIMO with two spatial streams - MRC - 802.11ac beamforming - 20-, 40-, 80- MHz channels - PHY data rates up to 866.7 Mbps (80 MHz with 5GHz) - Packet aggregation: A-MPDU (transmit and receive), A-MSDU (transmit and receive) - 802.11 DFS - CSD support - WPA3 support |
|
802.11ax |
- 2x2 uplink/downlink MU-MIMO with two spatial streams - Uplink/downlink OFDMA - TWT - BSS coloring - MRC - 802.11ax beamforming - 20-, 40-, 80- channels - PHY data rates up to 1.488 Gbps (80 MHz with 5 GHz and 20 MHz with 2.4 GHz) - Packet aggregation: A-MPDU (transmit and receive), A-MSDU (transmit and receive) - 802.11 DFS - CSD support - WPA3 support |
|
Integrated antenna |
- 2.4 GHz: Peak gain 3 dBi, internal antenna - 5 GHz: Peak gain 5 dBi, internal antenna |
|
Interfaces |
- 1x 100/1000/2500 Base-T (Ethernet) Uplink Interface - 3x 10/100/1000 Base-T (Ethernet) Downlink Interface (LAN1,LAN2 and LAN3, LAN1 supports 10.5W PSE Power Budget) - Management console port (RJ-45) - USB 2.0 at 4.5W - Passthru Port |
|
Indicators |
Status LED indicates boot loader status, association status, operating status, boot loader warnings, and boot loader errors |
|
Dimensions (W x L x H) |
3.54 x 6.3 x 1.3 in. (90 x 160 x 32.66 mm) |
|
Weight |
0.8 lb. (373.2g) |
|
Input power requirements |
- 802.3at Power over Ethernet Plus (PoE+), Cisco Universal PoE (Cisco UPOE ®) - Cisco power injector, AIR-PWRINJ6= - 802.3af PoE - Cisco power injector, AIR-PWRINJ5= |
|
PoE power |
- 802.3af (PoE) - 802.3at (PoE+): Either USB or LAN1 PSE enabled. |
|
Link speed |
- 2.5G mGig |
|
Environmental |
- Nonoperating (storage) temperature: -22° to 158°F (-30° to 70°C) - Nonoperating (storage) altitude test: 25˚C, 15,000 ft (4600 m) - Operating temperature: 32° to 122°F (0° to 50°C) - Operating humidity: 10% to 90% (noncondensing) - Operating altitude test: 40˚C, 9843 ft.(3000 m) |
|
Available transmit power settings (Max/Min) |
- 2.4 GHz: 20 dBm (100 mW), -7 dBm (0.2 mW) - 5 GHz: 20 dBm (100 mW), -7 dBm (0.2 mW) |
| condition | new |
|---|
Log In