Access point Cisco C9136I-E
3009 $
Cisco Catalyst 9100 – an innovative series of corporate Internet access points that are equipped with state-of-the-art hardware and support modern patented technologies and methods Cisco.
Units of this level are profiled for modern high-tech firms and enterprises that value a high level of performance and safety..
Line of new hotspots Cisco Catalyst 9100 represented by the following models: Catalyst 9115, Catalyst 9117 And Catalyst 9120.
access point Catalyst 9115 – is a unique device based on 6-1st generation WI-FI or 802.11Oh, which provides a triple increase in the speed of receiving and transmitting an Internet signal.
Peculiarities
- Simultaneous operation on all frequencies
- Multi-gigabit network interface
- New power-saving mode extends battery life
- Technology support Trust Anchor, guaranteeing the authenticity of software and hardware
- Certification WIFI 6
- Three radio modules: 2,4 GHz, 5 GHz And Bluetooth Low Energy (BLE) 5.0
- Support OFDMA And MU-MIMO 4x4
Catalyst 9117 – enterprise-class wireless access point, it has a multi-gigabyte interface and supports frequency division technology OFDMA And MU-MIMO 8x8. In addition, the access point is equipped with three radio modules and supports up to five thousand connected clients..
Peculiarities
- Simultaneous operation on all frequencies
- Multi-gigabit network interface
- New power-saving mode extends battery life
- Technology support Trust Anchor, guaranteeing the authenticity of software and hardware
- Certification WIFI 6
- Three radio modules: 2,4 GHz, 5 GHz And Bluetooth Low Energy (BLE) 5.0
- Support OFDMA And MU-MIMO 8x8
Catalyst 9120 – the most progressive model among all access points based on a new data transfer protocol WI-FI 6. The model is equipped with 4 radio modules and is produced with both internal and external antennas..
Peculiarities
- Certification WIFI 6
- Four radio modules: 2,4 GHz, 5 GHz, 5 GHz (dedicated radio module) And Bluetooth Low Energy (BLE) 5.0
- Support OFDMA And MU-MIMO 8x8
- Simultaneous operation on all frequencies
- Multi-gigabit network interface
- New power-saving mode extends battery life
- Technology support Trust Anchor, guaranteeing the authenticity of software and hardware
|
Software |
Cisco IOS ® XE Software Release 17.7.1 or later |
|
Supported wireless LAN controllers |
Cisco Catalyst 9800 Series Wireless Controllers (physical or virtual) |
|
802.11n version 2.0 (and related) capabilities |
- 4x4 MIMO with four spatial streams - Maximal Ratio Combining (MRC) - 802.11n and 802.11a/g - 20- and 40-MHz channels - PHY data rates up to 1.5 Gbps (40 MHz with 5 GHz and 20 MHz with 2.4 GHz) - Packet aggregation: Aggregate MAC Protocol Data Unit (A-MPDU) (transmit and receive), Aggregate MAC Service Data Unit (A-MSDU) (transmit and receive) - 802.11 Dynamic Frequency Selection (DFS) - Cyclic Shift Diversity (CSD) support |
|
802.11ac |
- 8x8 downlink MU-MIMO with eight spatial streams - MRC - 802.11ac beamforming - 20-, 40-, 80-, and 160-MHz channels - PHY data rates up to 3.4 Gbps (8x8 80 MHz or dual 4x4 80+80 MHz on 5 GHz) - Packet aggregation: A-MPDU (transmit and receive), A-MSDU (transmit and receive) - 802.11 DFS - Cyclic Shift Diversity (CSD) support - Wi-Fi Protected Access (WPA) 3 support |
|
802.11ax |
- 8x8 uplink/downlink MU-MIMO with eight spatial streams (5 GHz) - 4x4 uplink/downlink MU-MIMO with four spatial streams (2.4 and 6 GHz) - Uplink/downlink OFDMA - TWT - BSS coloring - MRC - 802.11ax beamforming - 20-, 40-, 80-, and 160-MHz channels (6 GHz) - 20-, 40-, 80-, 80+80-MHz (5 GHz) - 20-MHz channels (2.4 GHz) - PHY data rates up to 10.2 Gbps (4x4 160 MHz on 6 GHz, 8x8 80 MHz on 5GHz, and 4x4 20 MHz on 2.4 GHz) - Packet aggregation: A-MPDU (transmit and receive), A-MSDU (transmit and receive) - 802.11 DFS - CSD support - WPA3 support |
|
Integrated antenna |
- 2.4 GHz: Peak gain 4 dBi, internal antenna, omnidirectional in azimuth - 5 GHz: Peak gain 5 dBi, internal antenna, omnidirectional in azimuth - 6 GHz: Peak gain 6 dBi, internal antenna, omnidirectional in azimuth |
|
Interfaces |
- 2x 100M/1000M/2.5G/5G Multigigabit Ethernet (RJ-45) - Management console port (RJ-45) - USB 2.0 at 9W |
|
Indicators |
Status LED indicates boot loader status, association status, operating status, boot loader warnings, and boot loader errors |
|
Dimensions (W x L x H) |
9.9 x 9.9 x 2.2 in. (25.1 x 25.1 x 5.6 cm) |
|
Weight |
3.6 lb. (1.65 kg) |
|
Input power requirements |
- 802.3bt Cisco Universal PoE (Cisco UPOE ®), 802.3at Power over Ethernet Plus (PoE+) - Cisco power injector, AIR-PWRINJ7= - 802.3af PoE (only for configuration staging, all radios off) |
| condition | new |
|---|
Log In