Module Cisco IEM-3300-8P=
6314 $
Catalyst IE3300 w 8 GE PoE Copper ports Expansion Module
Interface or linear modules Cisco (line card, interface module) allow you to expand the router or modular platform with the required functionality, including the required speed ports at speed 1GbE, 10GbE, 40GbE or 100GbE. Mainly under each series of modular routers or chassis Cisco It produces various extensions under a certain line of devices, but in most cases the module can be used in not one line (eg. interface module Cisco EHWIC-4ESG Compatible with routers Cisco ISR G2 1900 series, 2900 series and 3900 series).
Depending on the platform, interface module Cisco can support a small number of ports as in the case of small routers Cisco 1900 series, as well as 48 ports in one module for chassis 7600 series. Interface modules and fees Cisco Supports a variety of different interfaces and can be used as in the network Ethernet, and in other data networks.
The technical characteristics of the interface module Cisco IEM-3300-8P=:
| Parameter | Specification |
|---|---|
| Model | Cisco IEM‑3300‑8P= |
| Module Type | Copper PoE/PoE+ Expansion Module |
| Compatible Base Platform | Cisco Catalyst IE‑3300 / IE‑3400 Rugged Series Switches |
| Slot Location | Side-mounted module slot on host chassis |
| Ports | 8 × 1 Gbps RJ‑45 copper PoE/PoE+ ports |
| Port Speed & Auto‑MDIX | 10/100/1000 Mbps with Auto‑MDIX; supports full and half duplex |
| Power over Ethernet (PoE) | Yes — up to IEEE 802.3at PoE+ (30 W per port) |
| PoE Budget | Total PoE budget up to 240 W (dependent on host switch power source) |
| Switching Performance | Line-rate, non-blocking forwarding across all module ports |
| MAC Address Table | Shared with host switch; capacity up to approximately 24,000 entries |
| Power Source | Powered from host IE‑3300 / IE‑3400 chassis |
| Typical Power Use (Module) | Around 80 W (including module electronics and PoE load) |
| Hot-Swappable? | No — installation requires the host switch to be powered down |
| Operating Temperature | –40 °C to +75 °C |
| Storage Temperature | –40 °C to +85 °C |
| Operating Humidity | 5% to 95%, non‑condensing |
| MTBF (Mean Time Between Failures) | Typically over 300,000 hours |
| Dimensions (H × W × D) | Approximately 140 mm × 90 mm × 150 mm |
| Weight | Approx. 1.2 kg (2.6 lbs) |
| Mounting Method | Installed into chassis: DIN-rail or wall-mount supported |
| Environmental & Safety Ratings | Inherits industrial certifications and rugged compliance of base switch |
| Primary Use Case | Adds 8 PoE-enabled copper Ethernet ports for powering industrial devices such as cameras or access points |
| condition | new |
|---|
Log In